Dell PowerEdge R750 EMC Installation and Service Manual - Page 156
Removing a GPU
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Removing a GPU Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. If applicable, disconnect the cables from the expansion card. 4. Remove the GPU air shroud top cover. 5. Remove the GPU air shroud filler. 6. Remove the full length expansion card riser. Steps 1. To remove the GPU from Riser 1: a. Disconnect the GPU power cable from the GPU card. b. Open the expansion card holder latch on the riser. c. Press the tab, and pull the card holder from the riser. d. Hold the GPU card by the edges and pull the card from the riser. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Figure 153. Removing GPU from Riser 1 2. To remove the GPU from Riser 4: a. Slide the expansion card latch on the riser. b. Disconnect the GPU power cable from the GPU card. c. Press the tab, and pull the card holder from the riser. d. Open the expansion card holder latch on the riser. e. Hold the GPU card by the edges and pull the card from the riser. 156 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/156.png)