Dell PowerEdge R750 EMC Installation and Service Manual - Page 176
Installing the BOSS S2 card carrier blank, Removing the BOSS S2 module
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Next steps 1. Replace the BOSS S2 card carrier blank or install BOSS S2 card carrier. Installing the BOSS S2 card carrier blank Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. Steps Align the blank with the BOSS S2 module bay and push it into the bay until it clicks into place. Figure 178. Installing the BOSS S2 card carrier blank Removing the BOSS S2 module The procedure to remove is the BOSS S2 module with 4 x 2.5-inch rear drive module is same. Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. Steps 1. Pull and lift the BOSS S2 card carrier retention latch lock to open. 2. Slide the BOSS S2 card carrier out. 176 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/176.png)