Dell PowerEdge R750 EMC Installation and Service Manual - Page 168
Installing the VGA port, Removing the VGA port
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
Figure 168. Removing the VGA port 5. Install the filler bracket if not replacing the VGA port. Next steps 1. Replace the VGA port. Installing the VGA port The procedure to install VGA port from Riser 3 or 4 is same. Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the air shroud or remove the GPU air shroud. 4. Remove expansion card riser. NOTE: VGA port is supported only in slot 4 or slot 8 of the expansion card riser. Steps 1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser. 2. Slide the VGA port into the expansion card riser. 168 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/168.png)
Figure 168. Removing the VGA port
5.
Install the filler bracket if not replacing the VGA port.
Next steps
1.
Replace the VGA port
.
Installing the VGA port
The procedure to install VGA port from Riser 3 or 4 is same.
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
Remove the air shroud
or
remove the GPU air shroud
.
4.
Remove expansion card riser
.
NOTE:
VGA port is supported only in slot 4 or slot 8 of the expansion card riser.
Steps
1.
Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2.
Slide the VGA port into the expansion card riser.
168
Installing and removing system components