Dell PowerEdge R750 EMC Installation and Service Manual - Page 165
Installing the serial COM port, Removing the Serial COM port
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
Figure 164. Removing the Serial COM port 5. Install the filler bracket if not replacing the serial COM port. Next steps 1. Replace the serial COM port. Installing the serial COM port The procedure to install serial COM port from Riser 3 or 4 is same. Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the air shroud or remove the GPU air shroud. NOTE: The serial COM port is supported only in slot 4 or slot 8 of the expansion card riser. Steps 1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser. 2. Slide the serial COM port into the expansion card riser and close the latch. Installing and removing system components 165