Dell PowerEdge R750 EMC Installation and Service Manual - Page 181
System battery, Replacing the system battery
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
Figure 186. Installing the BOSS S2 card carrier Next steps 1. Follow the procedure listed in the After working inside your system. System battery Replacing the system battery Prerequisites WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type That is recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the Safety instructions. that came with your system for more information. 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. If applicable, disconnect the power or data cables from the expansion cards. 4. Remove the expansion card risers. Steps 1. To remove the battery: a. Use a plastic scribe to pry out the system battery. CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery. Installing and removing system components 181