Dell PowerEdge R750 EMC Installation and Service Manual - Page 205
Installing the left control panel
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Installing the left control panel Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the drive backplane cover. 4. If installed, remove the air shroud or remove the GPU air shroud. 5. Remove the cooling fan cage assembly. 6. Remove the side wall bracket. Steps 1. Align and slide the left control panel in the slot on the system. 2. Route the left control panel cable through the side wall of the system. 3. Align and slide the left control panel cable cover in the slot on the system. NOTE: Route the cable properly to prevent the cable from being pinched or crimped. 4. Connect the left control panel cable to the connector on the system board . 5. Using the Phillips #1 screwdriver, tighten the screws to secures the left control panel and the cable cover to the system. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Figure 213. Installing the left control panel Next steps 1. Install the side wall bracket. 2. Install the cooling fan cage assembly. 3. Install the drive backplane cover. 4. If removed, install the air shroud or install the GPU air shroud. 5. Follow the procedure listed in After working inside your system. Installing and removing system components 205