Epson R200 Service Manual - Page 19

EPSON Stylus Photo R200/R210 Revision A Occurrence Timing Position of CR At operation Out of HP Table 1-7. Check Points for Paper Jam Error to Each Phenomenon Phenomenon Detail Faulty Part/ Part Name Check Point Remedy "Carriage Unit" moves to the home position properly when turning on the power. Then paper feeding operation is performed normally, but paper is not sent into the printer. PE Sensor* 1. Check if "Torsion Spring, 0.22" for "PE Sensor Lever" is not unfastened. 2. Check if "PE Sensor Cable" is correctly mounted on "Holder, Shaft, LD Roller". 1. Reassemble "Torsion Spring, 0.22". 2. Remount "PE Sensor Cable" correctly. 1. Check if "Roller, Retard Assy." operates properly while 1. Reassemble "Extension Spring, 0.45" back of feeding paper. "Roller, Retard Assy." When feeding paper, the leading edge of paper is detected properly, but the paper is ejected without being set at the print start position. At this time, the next paper is fed to "PE Sensor Lever". ASF Assy. At operation - The leading edge of paper does not go through between "Roller EJ Assy." and "Star Wheels". Frame EJ Assy.** 1. Check if "Star Wheels" have not come off. 2. Check if "Frame EJ Assy." is correctly assembled. 3. Check if "Frame EJ Assy." is not transformed toward downward. Paper Guide, Front 1. Check if "porous pad" of "Paper Guide, Front" has not come off. 1. Check if "Roller EJ Assy." is correctly assembled. 2. Check if "Spur Gear, 41.48" has not come off. Extension Spring, 0.45 1. Reassemble "Star Wheels" correctly. 2. Reassemble "Frame EJ Assy." correctly. 3. Replace "Frame EJ Assy." with a new one. 1. Remount "porous pad" correctly. 1. Reassemble "Roller EJ Assy." correctly onto "Printer Mechanism". 2. Reattach "Spur Gear, 41.48" to "Roller EJ Assy." correctly. Roller EJ Assy. Spur Gear, 41.48 TROUBLESHOOTING Unit Level Troubleshooting 19