Epson R200 Service Manual - Page 63
Check if Frame, EJ Assy. works with CDR Guide Assy.
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
EPSON Stylus Photo R200/R210 o External View (Cont.) Groove Star Wheel/CDR Sensor Compression Spring, 5.1 Lock, Stacker Hooks Shaft and Positioning Hole Figure 2-40. "CDR Guide Assy."removal (3) 8. Remove "Compression Spring, 5.1" and "Lock, Stacker" from "CDR Guide, Upper". Revision A 9. Release the connector cable of "Star Wheel/CDR Sensor" from the groove of "CDR Guide, Upper". o When reinstalling "Star Wheel/CDR Sensor", n Match the Shaft (x2) of "CDR Guide, Upper" and the positioning hole of "Star Wheel/CDR Sensor". n Mount correctly the connector cable of "Star Wheel/CDR Sensor" referring to the figure. o When reinstalling "CDR Guide, Upper" n Make sure that the hooks (x2) of "Lock Stacker" are properly secured by the tension of "Compression Spring, 5.1". n Make sure that "CDR Guide, Upper" is securely secured with the hooks (x7) of "CDR Guide, Lower" and there is no gap between "CDR Guide, Upper" and "CDR Guide, Lower". o When reinstalling "CDR Guide Assy.", n Place the the connector cable of "Star Wheel/CDR Sensor" on the red circle position of acetate tape. n Place the the connector cable of "Star Wheel/CDR Sensor" along with "Link, CDR Right" with standing "CDR Tray Assy." vertically. n Install "CDR Guide Assy." in the order of left edge, right edge and middle. n Match the slot (x6) of "CDR Guide Assy." and the ribs (x6) of "Frame, Main". n Check if "Link, CDR Left (Right)" is correctly installed. n Check if the connector cable of "Star Wheel/CDR Sensor" is not interrupting "Link, CDR Right". n Check if "Frame, EJ Assy." works with "CDR Guide Assy." and moves smoothly. DISASSEMBLY AND ASSEMBLY Disassembly 63