Epson R200 Service Manual - Page 53

EPSON Stylus Photo R200/R210 o External View (Cont.) Bushing, Parallel Adjust, Right C.P.S (P4) 3x6 (6-8kgf•cm) Holder, FFC ; B C.P.B (P1) 1.7x5 (1.5-2.5kgf•cm) CR Encoder Sensor Board Hooks CSIC Board Connector Timing Belt Holder Pad, Ring Oil Pad, Ring Extension Spring, 26.46 Pulley, Driven Hooks CR Encoder Sensor Board PW Sensor FFC 2 1 C.P.B (P1) 1.7x5 Connector Slot (1.5-2.5kgf•cm) Figure 2-24. "Carriage Unit" removal (3) Revision A 16. Remove the screw (x1) for securing "Bushing, Parallel Adjust, Left". Then, remove "Bushing, Parallel Adjust, Left". 17. Remove "Timing Belt" from "Carriage Unit". 18. Remove the screws (x2) for securing "Holder, FFC; B". Then, remove "Holder, FFC; B". 19. Remove "Cable, Head" from the connectors of "CSIC Board" and "CR Encoder Sensor Board". Then, remove "Cable Head" from "Carriage Unit". 20. Release the hooks (x2) from "Holder Pad, Ring" (x2). Then, remove "Holder Pad, Ring" (x2) and "Oil Pad, Ring" (x2). n "Pulley, Driven" removal 1. Remove "Extension Spring, 26.4 6" from "Pulley Driven" and the hook of "Frame, Main" by using a flat-blade screwdriver. Then, remove "Extension Spring, 26.46". 2. Slide "Pulley, Driven" in the direction of the arrow. Then, remove "Frame, Main" from the slot. n "CR Encoder Sensor Board" removal 1. Remove the screw which secures "CR Encoder Sensor Board" with Phillips screwdriver (No.0). Disconnect "PW Sensor FFC" from the connector of "CR Encoder Sensor Board". Then, remove "CR Encoder Sensor Board". DISASSEMBLY AND ASSEMBLY Disassembly 53