Epson R200 Service Manual - Page 80

EPSON Stylus Photo R200/R210 Revision A 3.2.4 Head Angular Adjustment [Adjustment Procedure] 1. Select Head Angular Adjustment in the Adjustment Program. 2. Click the [Print] button to print Head Angular Adjustment Pattern of checked items. 3. Select the pattern value of straight line in the printed lines. 4. Click the [input] button and write the adjustment value. (Note: The range of the adjustment value is -3 to 3.) [Treatment procedure for NG product] 1. Replace the Print Head with new one again. 2. Print the check pattern, and check the adjustment result. 3. If the result is NG level, confirm the installation condition of removed parts during disassembly. 4. Perform step2) again. OK pattern NG pattern [Judging Standard] - The printed line should be straight line. [Reference: Standard value in manufactory] - Standard: ± 50µm 3.2.5 Bi-d Adjustment [Adjustment Procedure] 1. Select Bi-D Adjustment in the Adjustment Program. 2. Click the [Print] button to print Bi-D Adjustment Pattern of checked items. 3. After selecting the pattern that has the smallest misalignment in each variable dot, click the [Go to input page] button in the Adjustment Program. 4. Click the [Input] button to write the adjustment value of checked items. 5. Click the [Go to print page] button. [Treatment procedure for NG product] 1. Replace the Print Head with new one again. 2. Print the check pattern, and check the adjustment result. 3. If the result is NG level, confirm the installation condition of removed parts during disassembly. 4. Perform step2) again. OK pattern NG pattern [Judging Standard] - No gap/overlap between short block pattern and long one. [Reference: Standard value in manufactory] VSD1: 60µm, VSD2: 60µm, VSD3: 40µm, VSD4: 40µm, ECO: 85µm. Figure 3-1. Head Angular Printing Pattern Figure 3-2. Bi-D Adjustment Pattern ADJUSTMENT Adjustment by using adjustment program 80