Epson R200 Service Manual - Page 40
ASF Unit removal
![]() |
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
EPSON Stylus Photo R200/R210 2.3.3 ASF Unit removal o External View C.B.S 3x6 (5-7kgf/cm) C.B.S(P4) 3x6 (5-7kgf/cm) C.B.P 3x8 (5-7kgf/cm) Backside C.B.S 3x6 (5-7kgf/cm) ASF Unit Screw, ASF (4-5kgf/cm) Acetate tape CN14 Screw, Frame, Main 3x6 (5-7kgf/cm) Paper Return Lever C.B.P 3x6 (3-5kgf/cm) CN11 Board, Main Support Plate, Frame, ASF Torsion Spring 6.45 Extension Spring 0.45 Roller, Retard Assy. Figure 2-6. ASF Unit removal Revision A o Parts/Units which should be removed before removing "ASF Unit" Paper Support Assy./Housing (left/right)/Housing (frame) o Disassembly Procedure 1. Disconnect the PG sensor connector cable & the CDR tray sensor cable from the connector (CN14/CN11) of the "Board, Main". 2. Remove the screws (x5) for securing "ASF Unit", and remove "ASF Unit" to the backside of the printer. 3. Remove the screws (x3) for securing the PG sensor connector cable & the CDR tray sensor cable to ASF frame, and release the cables. 4. Remove the ASF unit backward. 5. Open "Hopper" and then remove "Compression Spring, 2.51". 6. Bow slightly down "Paper Return Lever" and release the dowels (x2) on the both sides in the order of 1 , 2 ., and remove "Paper Return Lever". C A U T IO N When removing "Paper Return Lever", the spring washer will detach and drop. Take care not to lose it. 7. Remove the screws (x2) for securing "Support Plate, Frame, ASF". 8. Release the hooks (x2) for securing "Extension Spring, 0.45", and remove "Roller, Retard Assy.". DISASSEMBLY AND ASSEMBLY Disassembly 40
![](/manual_guide/products/epson-r200-service-manual-1506266/40.png)