Epson R200 Service Manual - Page 54
When removing Cap, PW Sensor, PW Sensor Board will - stylus photo cartridge
![]() |
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
EPSON Stylus Photo R200/R210 o External View (Cont.) Cap, PW Sensor PW Sensor Board Connector Hooks Torsion Spring, Lever, Cartridge Hook Dowel Guide, IC Lever, Cartridge Slot and Dowel C.B.P 2.5x8 (3-5kgf•cm) Electric Pole Hooks Hook CSIC Board Revision A n "PW Sensor Board" removal 1. Release the hooks (x3) which secure "Cap, PW Sensor". Then, remove "Cap, PW Sensor". C A U T IO N When removing "Cap, PW Sensor", "PW Sensor Board" will be free. Therefore, take care not to damage "PW Sensor Board". 2. Pull out "PW Sensor Board" from the slot of "Carriage Unit". Then, remove "PW Sensor FFC" from the connector of "PW Sensor Board" and remove "PW Sensor Board" and "PW Sensor FFC". n "CSIC Board" removal 1. Remove "Torsion Spring, Lever, Cartridge" from the hook and the dowel of "Guide, IC". 2. Remove the dowel of "Lever, Cartridge" from the slot on the right side of ""Guide, IC" by using the tweezers. Then, remove "Lever, Cartridge. 3. Remove the screws (x2) for securing "Guide, IC", then release the hook with the tweezers. And remove "Guide, IC". 4. Release the hooks (x2) for securing "CSIC Board", then push up "CSIC Board" from the slot located on the bottom of "Carriage Unit" with a flatblade screwdriver or alike. Finally, remove "CSIC Board". C A U T IO N Do not damage the electric pole with the flat-blade screwdriver or alike when removing "CSIC Board". Slot Figure 2-25. "CR Unit" removal (4) DISASSEMBLY AND ASSEMBLY Disassembly 54
![](/manual_guide/products/epson-r200-service-manual-1506266/54.png)