Epson R200 Service Manual - Page 57
Printer Mechanism/Housing lower, removal
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
EPSON Stylus Photo R200/R210 2.3.12 Printer Mechanism/Housing (lower) removal o External View C.B.S 3x6 (5-7kgf•cm) C.B.S 3x6 (6-8kgf•cm) C.B.P 3x10 (6-8kgfcm) 1 2 1 2 3 C.B.P 3x8 (5-7kgf•cm) Paper Guide, CDR C.B.P 3x10 (6-8kgf•cm) Revision A 2 ± 1mm Hooks Acetate Tape Handling Position Hook 4 3 5 Screw, Frame, Main (6-8kgf•cm) Combination Gear, 27.2, 19.2 Lever, Change Hook (Under the tube) Wire Band Figure 2-29. "Printer Mechanism"/"Housing, Lower" removal (1) Figure 2-30. "Printer Mechanism"/"Housing, Lower" removal (2) o Parts/Units which should be removed before removing "Printer Mechanism"/Housing (lower) Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Unit/Main Board/ Holder, Shaft Unit o Disassembly Procedure 1. Move "Carriage Unit" to the centre of the printer. 2. Remove the screws (x3) for securing "Paper Guide, CDR". 3. Remove the screws (x5) for securing "Printer Mechanism". 4. Take off the acetate tape and release the connector of "Star Wheel/CDR Sensor". 5. Cut off the wire band and release the connector cable. 6. Release the hooks (x4) for securing "Printer Mechanism". Then, hold the both right and left upper edges of "Frame, Main" and remove "Printer Mechanism" to upward. DISASSEMBLY AND ASSEMBLY Disassembly 57