Epson R200 Service Manual - Page 44
Porous Pad, Paper Guide, Front removal
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
EPSON Stylus Photo R200/R210 2.3.6 Porous Pad, Paper Guide, Front removal o External View PPoorroouussPPaadd, ,PPaappeerrGGuuididee, ,FFrroonntt, ,LLeefftt Porous Pad, Paper Guide, Front Porous Pad, Paper Guide, Front, Support Folding Points Figure 2-10. "Porous Pad, Paper Guide, Front" removal o Pars/Units which should be removed before removing "Porous Pad, Paper Guide, Front" Paper Support Assy./Housing (left/right)/Housing (frame) o Disassembly Procedure 1. Remove the following 3 types of porous pads from "Paper Guide, Front" by using the tweezers. • Porous Pad, Paper Guide, Front • Porous Pad, Paper Guide, Front, Support • Porous Pad, Paper Guide, Front, Left C A U T IO N Make sure to take "Porous Pad, Paper Guide, Front" cleanly as it is glued. Revision A Vertical Direction: 4 ± 1mm Horizontal Direction: 1-2mm Horizontal Direction : 3-4mm Horizontal Direction : 5-6mm Vertical Direction: 4 ± 1mm Horizontal Direction: 2-3mm Figure 2-11. Gluing Point of "Porous Pad, Paper Guide, Front" o When reinstalling "Porous Pad, Paper Guide, Front"/"Porous Pad, Paper Guide, Front, Support" n Fold perpendicularly left and right sides of "Porous Pad, Paper Guide, Front, Support" at the marks and install it to "Paper Guide, Front". Make sure that the slit engages with the rib located on the side of "Paper Guide, Front" so that they will fit securely. n Apply ThreeBond 1401 to the 6 points shown in the figure above. n Install "Porous Pad, Paper Guide, Front" in piles. Put it under the rib, and check if it is securely fit. Adjust the clearance between "Porous Pad, Paper Guide, Front" and "Paper Guide, Front" approximately in 0.5 - 1.0mm. o When reinstalling "Porous Pad, Paper Guide, Front, Support" n Insert the foot-parts into the holes of "Paper Guide, Front". Then, put them under the rib and check if it is securely fit. C A U T IO N o Do not damage "Porous Pad, Paper Guide, Front, Support". o Do not apply too much adhesive when using some. Do not contaminate "Porous Pad, Paper Guide, Front, Support" with the adhesive. o Install "Porous Pad, Paper Guide, Front" immediately after applying the adhesive. o Make sure that the 3 porous pads are fit securely. DISASSEMBLY AND ASSEMBLY Disassembly 44