Epson R200 Service Manual - Page 8
Overview - stylus photo troubleshooting
![]() |
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
EPSON Stylus Photo R200/R210 Revision A 1.1 Overview This chapter describes how to identify troubles in two levels: unit level repair and component level repair. Refer to the flowchart in this chapter to identify the defective unit and perform component level repair if necessary. This chapter also explains motor coil resistance, Sensor specification and error indication. START UNIT-LEVEL TROUBLESHOOTING UNIT REPAIR ASSEMBLY AND ADJUSTMENT END Figure 1-1. Troubleshooting Flowchart Motor PF Motor (Same as ASF/ Pump Motor) Table 1-1. Motor, Coil Resistance Location Check Point Pin 1 and 3 CN6 Pin 2 and 4 Resistance 3.0W ±10% (25°C/phase) Since "CR Motor" and APG Motor are DC motors, the resistance among the electric poles varies. Therefore, judge if it is normal or abnormal based on if there is operation of the motor or not; the resistance values cannot be used to judge the abnormality. However, it is difficult to judge accurately, if it is not clear, replace the motor. Sensor name PE Sensor PG Sensor Star Wheel Sensor CDR Sensor Table 1-2. Sensor check point Location Check point Signal level Switch mode More than 2.4V Off : No paper CN9 Pin 1 and 2 Less than 0.4V On : Detect paper CN14 Pin 1 and 2 More than 2.4V Off : Anywhere of PG On : Less than 0.4V In process of switching PG CN11 Pin 1 and 2 - On : ASF mode - Off : CDR mode CN11 Pin 3 and 4 - Off : No CDR Tray - On : Detect CDR Tray TROUBLESHOOTING Overview 8
![](/manual_guide/products/epson-r200-service-manual-1506266/8.png)