Epson R200 Service Manual - Page 48
When reinstalling Holder, Shaft Unit
![]() |
UPC - 010343849532
View all Epson R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
EPSON Stylus Photo R200/R210 o When reinstalling "Clutch", n Make sure that the dowel of "Shaft, LD Roller" is fitted in the installing hole of "Clutch". n Make sure that "Extension Spring, 0.143" is securely set on the hooks of "Clutch" and "Shaft, LD Roller". n Do not set "Extension Spring, 0.143" in twisted form. n Make sure that "Clutch" rotates correctly. o When reinstalling "Shaft, LD Roller", n Do not touch "LD Roller". n Check if the straight part of "Torsion Spring, 137.7" is set between the 2 cams of "Shaft, LD Roller". Torsion Spring, 137.7 Revision A o When reinstalling "Holder, Shaft Unit", n Check if the hooks (x2), the dowel and the ribs (x5) of "Holder, Shaft Assy." are correctly secured. n Check if the connector cable of "PE Sensor" and "Cable, Head" are installed at the correct position of "Holder, Shaft Assy.". n Do not touch "LD Roller". n Do not damage the teeth of "Spur Gear, 36.8" and "Combination Gear, 27.2, 19.2". Make sure that the straight part of "Torsion Spring, 137.7" is set between the two cams. LD Roller Figure 2-16. Position of "Torsion Spring, 137.7" Combination Gear, 27.2, 19.2 Spur Gear, 36.8 Figure 2-17. "Spur Gear, 36.8" and "Combination Gear, 27.2, 19.2" A D JU S TM E N T R E Q U IR E D o When having replaced "Shaft, LD Roller", apply G-46 grease to the specified points in adequate dose. (Refer to Chapter 4 "MAINTENANCE") o When having replaced or removed "Holder, Shaft Unit", implement the following adjustment. (Refer to Chapter 3 "ADJUSTMENT") n First Dot Adjustment DISASSEMBLY AND ASSEMBLY Disassembly 48
![](/manual_guide/products/epson-r200-service-manual-1506266/48.png)