Gateway 995 995 Series Server User Guide - Page 147
Keyboard, Memory, To repair the master boot record
View all Gateway 995 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Troubleshooting The master boot record is corrupted ■ In a Windows network operating system, repair the master boot record using FDISK. To repair the master boot record: ■ At a DOS command prompt, type fdisk/mbr, then press ENTER. Keyboard Liquid has been spilled into the keyboard ■ If you spilled liquid in the keyboard, turn off your server and unplug the keyboard. Clean the keyboard and turn it upside down to drain it. Let the keyboard dry before using it again. If the keyboard does not work after it dries, you may need to replace it. This type of damage is not covered by your server's warranty. Memory Caution Modules must be installed in identical groups of four. Use only PC1600 (DDR-200) or PC2100 (DDR-266) compliant, SDRAM registered ECC, DIMM memory modules. Install memory first into Bank 1, Bank 2, then Bank 3. If memory is installed incorrectly, your server will not start. Partially filled banks are ignored by the server. For the most reliable and stable operation, we recommend you use memory from the same manufacturer in all memory banks. Memory errors were detected during server start up ■ Open your server and make sure that the memory modules are installed correctly. For instructions, see "Installing memory" on page 86. ■ A memory module may be defective. If possible, try another memory module and see if the error repeats. www.gateway.com 141