Gateway 995 995 Series Server User Guide - Page 43

Preparing to install components Before working with server components, follow these guidelines: ■ Turn off the server, then unplug the power cords and all other cables. ■ Press the power button to drain any residual power from the server. ■ Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare metal part of the server. You can also touch a bare metal surface on the back of the server with your finger. ■ Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. ■ Avoid working on the server when your work area is extremely humid. ■ Remove components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection. ■ Always hold expansion cards by their edges or their metal mounting brackets. Avoid touching the edge connectors and components on the cards. Never slide expansion cards or components over any surface. Gathering the tools you need Some tools and supplies that you may need to work on your server are: ■ A notebook to take notes ■ A Phillips screwdriver ■ A small flat-blade screwdriver ■ Small containers to store various types of screws ■ A grounding wrist strap (available at most electronic stores) Getting Help If you have questions about performing any of these procedures, contact Gateway Technical Support. For more information, see "Getting Help" on page 8. www.gateway.com 37