HP 750c Service Manual - Page 57
Repair Procedures, Removing the ElectronicsĆEnclosure Cover
View all HP 750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Repair Procedures Removing the ElectronicsĆEnclosure Cover 1 Ensure that the plotter is switched off and that the power cord and interface cable(s) are not connected to it. 2 At the back of the plotter, ensure that the two small wire clamps of the parallel port are positioned vertically. No interface cables connected. Power inlet: cord not connected 3 Remove the screws that attach the cover to the electronics enclosure. D/A1Ćsize plotters have six screws. E/A0Ćsize plotters have eight screws. 4 Gently lift up the cover to an angle of 45_. Tx 10 or Flat C4705-90000 Removal and Replacement 6-5
1
Ensure that the plotter is switched
off
and that the power cord and interface
cable(s) are not connected to it.
2
At the back of the plotter, ensure that
the two small wire clamps of the parallel
port are positioned vertically.
No interface
cables connected.
Power inlet: cord
not connected
3
Remove the screws that attach the cover
to the electronics enclosure.
D/A1Ćsize plotters have six screws.
E/A0Ćsize plotters have eight screws.
or
Flat
Tx 10
4
Gently lift up the cover to an angle of 45
_
.
6-5
Removal and Replacement
C4705-90000
Repair Procedures
Removing the ElectronicsĆEnclosure Cover