HP LaserJet M1120 Service Manual - Page 108
disconnect one wire-harness connector callout 7. Remove the laser/scanner assembly.
View all HP LaserJet M1120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
7. Remove four screws (callout 6). NOTE: These four screws are longer than most of the screws used in the product. Do not get them mixed up with screws from previously removed components. Figure 5-68 Remove the laser/scanner assembly (6 of 7) 6 8. Carefully slide the laser/scanner assembly away from the main-motor PCA bracket, and then disconnect one wire-harness connector (callout 7). Remove the laser/scanner assembly. Figure 5-69 Remove the laser/scanner assembly (7 of 7) 7 92 Chapter 5 Removal and replacement ENWW
7.
Remove four screws (callout 6).
NOTE:
These four screws are longer than most of the screws used in the product. Do not get
them mixed up with screws from previously removed components.
Figure 5-68
Remove the laser/scanner assembly (6 of 7)
6
8.
Carefully slide the laser/scanner assembly away from the main-motor PCA bracket, and then
disconnect one wire-harness connector (callout 7). Remove the laser/scanner assembly.
Figure 5-69
Remove the laser/scanner assembly (7 of 7)
7
92
Chapter 5
Removal and replacement
ENWW