HP Latex 560 User Guide - Page 88
Change substrate width and right edge position, Substrate length tracking, Cut substrate
View all HP Latex 560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
- Ready: The wiper roller is loaded and ready for use. - Recommended to change: The wiper roller is loaded but has passed its expected lifetime: more than 1800 m (70866 in) printed. It may not work correctly. - Not present: The wiper roller is not installed. ● Wiper roller meters/inches printed The More actions button allows you to launch the following actions: ● Wiper roller replacement ● Take-up reel instructions If no substrate is loaded, the message Out of substrate appears. The same information appears on the Embedded Web Server's Supplies page. Change substrate width and right edge position If the substrate edges are not correctly found by the printer, they can be changed from the front panel by pressing , then Substrate > Substrate handling options > Substrate width. TIP: Bear in mind that automatic edge detection will not be attempted again until the next substrate load. Substrate length tracking The substrate length tracking feature enables you to keep track of how much substrate remains on the roll. 1. When the roll is first loaded onto the printer, you have the option (in the Load Configuration screen) to enter the length of substrate on the roll. The amount of substrate that is subsequently used is then tracked. 2. When the substrate is unloaded, the front panel displays the amount remaining so that you can note it for future reference. Cut substrate This option is available from the printer's front panel. If you press normally advances the substrate 150 mm (5.9 in) and cuts it. , then the scissors icon, the printer NOTE: If the cutter is disabled ( , then Substrate handling options > Cutter > Off), the printer advances the substrate but does not cut it. NOTE: Some banners and textiles cannot be cut. 82 Chapter 3 Handle the substrate and troubleshoot substrate issues ENWW