HP StorageWorks 2/140 CLI reference guide for directors and edge switches - Page 175
config.features.installKe, y on Error 83: Not Allowed
![]() |
View all HP StorageWorks 2/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
Error Messages Message Error 81: Default Zone Enabled Error 82: Invalid Interop Mode Error 83: Not Allowed in Open Fabric Mode Root> config switch interopMode open Error 88: Invalid Feature Key Length Description The request cannot be completed because the default zone is enabled. The value entered for the interoperability mode is not valid. Zone member cannot be put into the default zone while the product is operating in Open Fabric 1.0 mode. For example, if the following series of commands is entered, Error 83 results: Root> config zoning setDefZoneState true The value of the specified feature key is longer than the maximum length allowed. Action Disable the default zone before reentering the command. The interoperability mode for the Director or Edge Switch must be Homogenous Fabric or Open Fabric 1.0. Enter either Homogenous Fabric or Open Fabric 1.0 to set the interoperability mode. Root> maint system setOnlineState false Configure the interoperability mode as Homogenous Fabric in the previous series of commands. Refer to config.features.installKe y on page 2-5 for requirements, and reenter the feature key. If problems persist, contact your sales representative. CLI reference guide for directors and edge switches A-11
![](/manual_guide/products/hewlettpackard-316095b21-cli-reference-guide-directors-edge-switches-4b9015e/175.png)