HP StorageWorks 2/140 CLI reference guide for directors and edge switches - Page 85
config.switch.speed
![]() |
View all HP StorageWorks 2/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
CLI Commands config.switch.speed Syntax speed switchSpeed Purpose This command sets the speed for the Switch. NOTE: This command is only applicable for the Director 2/64. Edge Switches and the Director 2/140 cannot change speed. Description The Switch must be set offline before this command is entered. A Switch can be configured to operate at 1.0625 Gbps or 2.125 Gbps. If the Switch has fibre port module (FPM) cards, configuring the Switch speed to 2.125 Gbps makes all the ports on the FPM cards inactive, and their operational state will be set to inactive. FPM ports do not support 2.125 Gbps and, therefore, will remain inactive after the Switch is returned to the online state. Parameters This command has one required parameter: switchSpeed Specifies the speed of the Switch. Valid values are 1g (for 1.0625 Gbps) or 2g (for 2.125 Gbps). Command Examples Root> config switch speed 2g CLI reference guide for directors and edge switches 2-55
![](/manual_guide/products/hewlettpackard-316095b21-cli-reference-guide-directors-edge-switches-4b9015e/85.png)