HP StorageWorks 2/140 CLI reference guide for directors and edge switches - Page 31

2 CLI Commands This chapter describes command line interface (CLI) commands, including their syntax, purpose, and parameters, as well as examples of their usage and any output that they generate. Section Command Overview config Commands config.switch Commands config.zoning Commands maint Commands perf Commands show Commands Page 2 -1 2 -1 2 -44 2 -64 2 -81 2 -89 2 -101 Command Overview Most of the commands in this chapter are listed in alphabetical order to make them easy to locate. Although the commands can be entered in any order, depending on the results desired (so long as the tree structure is followed), the order used herein for the zoning commands follows a typical order of entry. The various show commands are usually entered at the end of a group of other commands. config Commands The config branch of the CLI command tree contains commands that set parameter values. These values are not temporary (session) values, but are retained across power cycles. The commands in the config branch can by used only by the administrator. CLI reference guide for directors and edge switches 2-1