HP StorageWorks 2/140 CLI reference guide for directors and edge switches - Page 47
config.port.speed, Syntax, Purpose, Description, Parameters, Command Examples
![]() |
View all HP StorageWorks 2/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
CLI Commands config.port.speed Syntax speed portNumber portSpeed Purpose This command sets the speed for a port. Description A port can be configured to operate at 1.0625 Gbps or 2.125 Gbps, or a negotiated speed. The port speed can be set only to 1.0625 Gbps if the Switch speed is 1.0625 Gbps. An attempt to set the port speed to 2.125 Gbps or to negotiate in a Switch with a 1 Gbps Switch speed results in an error message. If the port speed is set to negotiate, the port and the device to which it is attached negotiate the data speed setting to either 1.0625 or 2.125 Gbps. NOTE: Port speed changes temporarily disrupt port data transfers. Parameters This command has two required parameters: portNumber Specifies the port number. Valid values are: 0-15 for the Edge Switch 2/16 0-23 for the Edge Switch 2/24 0-31 for the Edge Switch 2/32 0-63 for the Director 2/64 portSpeed 0-127 and 132-144 for the Director 2/140 Specifies the speed of the port. Valid values are 1g, 2g, and negotiate. Command Examples Root> config port speed 4 2g Root> config port speed 6 negotiate CLI reference guide for directors and edge switches 2-17
![](/manual_guide/products/hewlettpackard-316095b21-cli-reference-guide-directors-edge-switches-4b9015e/47.png)