HP XM600 hp kayak xm600 series 2, user's guide for desktop models - Page 46

Installing the New System Board, and any accessory cards in the new

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

2 Installing and Replacing Hardware Parts in Your PC Workstation Replacing the System Board Installing the New System Board 1 Clip the retaining bracket onto the new system board. 2 Aligning the rear connectors with their corresponding sockets, insert the system board and lower it onto the guide pins. Ensure that all hooks are correctly positioned. Check that the rear connectors are correctly aligned in their sockets. 3 Replace the screw to secure the system board in place.    4 Attach the system board to the chassis using the four screws located near the … processor sockets. 5 Slide the front access cage back into position (described on page 37). 6 Reconnect any cables you disconnected earlier from the system board. 7 Replace the main memory, processor and any accessory cards in the new system board (described in this chapter). 8 Replace the PC Workstation's cover and front bezel (refer to page 23). Reconnect all the power and telecommunications cables. 9 After installing the system board, you need to update your BIOS. NOTE The latest BIOS for your PC and instructions on updating the BIOS are available from: www.hp.com/go/kayaksupport. 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
2
Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
46
Installing the New System Board
1
Clip the retaining bracket onto the new system board.
2
Aligning the rear connectors with their corresponding sockets, insert the
system board and lower it onto the guide pins. Ensure that all hooks are
correctly positioned. Check that the rear connectors are correctly
aligned in their sockets.
3
Replace the screw to secure the system board in place.
4
Attach the system board to the chassis
using the four screws located near the
processor sockets.
5
Slide the front access cage back into
position (described on page 37).
6
Reconnect any cables you disconnected
earlier from the system board.
7
Replace the main memory, processor
and any accessory cards in the new
system board (described in this
chapter).
8
Replace the PC Workstation’s cover and front bezel (refer to page 23).
Reconnect all the power and telecommunications cables.
9
After installing the system board, you need to update your BIOS.
NOTE
The latest BIOS for your PC and instructions on updating the BIOS are
available from:
www.hp.com/go/kayaksupport
.
²
´
±