HP Xw9300 HP xw9300 Service and Technical Reference Guide - Page 128
and install the processor into the socket. Ensure that the underside of the processor is level with the top
View all HP Xw9300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
To replace the processor: 1. Disconnect power from the system (page 79), remove the access panel (page 86), remove the CPU heatsink (page 116), and remove the processor (page 127). 2. Raise the processor socket handle fully (the full swing angle of the lever is approximately 90 degrees). CAUTION: Processor pins are delicate and bend easily. Use extreme care when placing the processor in the socket. 3. Line up the triangle on the top of the processor with the triangle on the corner of the processor socket and install the processor into the socket. Ensure that the underside of the processor is level with the top of the processor socket. Lightly press down on the top of the processor while closing the socket lever. 4. Check for proper processor seating in the socket by carefully trying to lift the processor out of the socket with your fingers. A properly seated processor does not lift out of the socket. 5. Replace the CPU heatsink (page 116). 128 Removal and Replacement Procedures