HP Xw9300 HP xw9300 Service and Technical Reference Guide - Page 159
Network Problems continued, Table 5-33
View all HP Xw9300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
System Diagnostics and Troubleshooting Table 5-33 Network Problems (continued) Problem Cause Solution Network controller stopped working when an expansion board was added to the workstation. Network controller interrupt is shared with an expansion board. Under the Computer Setup Advanced menu, change the resource settings for the board. The network controller requires Verify that the drivers were not accidentally deleted drivers. when the drivers for a new expansion board were installed. The expansion board installed is a network card (NIC) and conflicts with the embedded NIC. Under the Computer Setup Advanced menu, change the resource settings for the board. Network controller stops working without apparent cause. The files containing the network Reinstall the network drivers, using the Restore Plus! drivers are corrupted. CD. The cable is not securely connected. Be sure that both ends of the cable are securely attached to the correct devices. The network controller is defective. Replace the NIC. New network card will not boot. New network card might be Install a working, industry-standard NIC, or change defective or might not meet the boot sequence to boot from another source. industry-standard specifications. Cannot connect to network server when attempting Remote System Installation. The network controller is not configured properly. Verify Network Connectivity, that a DHCP Server is present, and that the Remote System Installation Server contains the NIC drivers for your NIC. System setup utility reports unprogrammed EEPROM. Unprogrammed EEPROM. Flash the ROM. See "ROM Flash" on page 59. Troubleshooting Scenarios and Solutions 159