HP dx7200 HP Compaq Business PC dx7200 MT Service Reference Guide, 1st edition - Page 113
Hood Sensor,
View all HP dx7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Removal and Replacement Procedures- Slim Tower (ST) Chassis 7.3 Hood Sensor 1. Prepare the computer for disassembly (Section 7.1). 2. Remove the computer cover (Section 7.5). 3. Remove the special security clip (Section 7.4.1) from the top rear corner of the power supply cage. 4. Raise the power supply to its full upright position. 5. Disconnect the hood sensor cable from the system board. 6. Slide the hood sensor switch mounted on the power supply towards the outside of the computer 1 and lower it through the slot 2. To install the hood sensor, reverse the removal procedure. Service Reference Guide, dx7200 390812-001 7-5
Service Reference Guide, dx7200
390812-001
7–5
Removal and Replacement Procedures— Slim Tower (ST) Chassis
7.3 Hood Sensor
1. Prepare the computer for disassembly (
Section 7.1
).
2. Remove the computer cover (
Section 7.5
).
3.
Remove the special security clip (
Section 7.4.1
) from the top rear corner of the power supply
cage.
4. Raise the power supply to its full upright position.
5. Disconnect the hood sensor cable from the system board.
6. Slide the hood sensor switch mounted on the power supply towards the outside of the
computer
1
and lower it through the slot
2
.
To install the hood sensor, reverse the removal procedure.