HP dx7200 HP Compaq Business PC dx7200 MT Service Reference Guide, 1st edition - Page 87
Drives, 6.9.1 Drive Positions
View all HP dx7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Removal and Replacement Procedures- Microtower (MT) Chassis 6.9 Drives The computer supports up to six drives that may be installed in various configurations. This Section describes the procedure for replacing or upgrading the storage drives. A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive. Ä CAUTION: Make sure personal files on the hard drive are backed up to an external storage device before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard drive, you will need to run the Restore Plus! CD to load the HP factory-installed files. 6.9.1 Drive Positions Drive Positions Item Description 1 Two 5.25-inch, half-height bays for optional drives 2 Two standard 3.5-inch, one-third height bays (1.44-MB diskette drive shown)* 3 Two internal 3.5-inch, one-third height bays for hard drives *A 3.5-inch diskette drive or zip drive may be installed in this bay but the correct bezel must be installed to ensure proper air flow. Service Reference Guide, dx7200 390812-001 6-15