Honeywell NX4S1 Installation Guide - Page 43
RS-485 Short Haul Modem Connection via PCI-2
View all Honeywell NX4S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
NetAXS™ NX4S1 Installation System Configuration 5.7 RS-485 Short Haul Modem Connection via PCI-2 This connection supports thirty-one NetAXS™ Access Controller panels for each drop line. It has not been reviewed by UL. Note that PCI-2 units can also be wired anywhere along the drop line. See Figure 18 on page 28 and Figure 19 on page 29. Figure 23: RS-485 Short Haul Modem Connection via PCI-2 RS-232, 50 Ft. Max. Terminal RS-485 Cable NetAXS Panels TB7-1 (RS485+) TB7-2 (RS485-) TB7-3 (RS485 COM) 4,000 ft. (1,200 m) max, 24 AWG, 2 twisted pairs with shield, 120 ohm, 23 pf (HAS part no. NCP2441-TN) SHM-B-ASYNCH Short Haul Modem DCE DTE DIP Switch Settings S1-S5 Panel Address S6: OFF J36: CLOSED J37: CLOSED DIP Switch Settings S1-S5 Panel Address S6: OFF J36: OPEN J37: OPEN 5279.9 Feet RX + RX TX + TX GROUND RS232 Cable MODEM PC DTE DCE (DB-9) (Straight) (Null) 2 TX 3 RX 5 Comm 2 (TX) 2 (RX) 3 (RX) or 3 (TX) 7 (GND) 7 (GND) (J1 RS-232 Connector) DN DIS RTSIDTR CONTROL (Jumper) (S2 Loopback) EG See RS-485 cable note EG SHM-B-ASYNCH Short Haul Modem DI S1: S2: S3: S4: S5: S6: S7: S8: OFF )19,200 Baud Rate) N-485-PCI-2 (RS-232 50 Ft. Max.) Male 9 Pin Male 25 Pin Refer to 485-PCI/NetAXS Panel Connection Detail diagram (S2 Loopback) RTSIDTR CONTROL DN DIS (Jumper) (J1 RS-232 Connector) RS232 Cable MODEM PC (DB-9) DTE DCE (Straight) (Null) 2 TX 3 RX 5 Comm 2 (TX) 2 (RX) 3 (RX) or 3 (TX) 7 (GND) 7 (GND) NetAXS Access Control Unit NX4S1 Installation Guide, Document 800-00008, Revision A 33