Honeywell NX4S1 Installation Guide - Page 53
Table 5, LED Status
View all Honeywell NX4S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
NetAXS™ NX4S1 Installation NetAXS™ Startup The following table indicates the status associated with each LED. Table 5 LED Status LED PWR RUN H485 H232 DS COM LINK RLY RDR GREEN Power OK Blink = Multi- RS232 Down- 100Mbit Link normal drop Receive stream OK Steady = Receive Data malfunc- Data Receive Data tion Relay Flash at Active read RED N/A N/A Trans-m Trans-m Trans-m N/A it Data it Data it Data N/A N/A N/A AMBER N/A N/A TX & TX & TX & N/A RX RX RX Data Data Data TX & N/A N/A RX Data OFF Power Mal- No No No 10Mbit No Relay Normal Off function Com Com Com Link Off Note: The Ethernet/COM status LED will be green even if no cable is attached. NetAXS Access Control Unit NX4S1 Installation Guide, Document 800-00008, Revision A 43
NetAXS™ NX4S1 Installation
NetAXS™ Startup
NetAXS Access Control Unit NX4S1 Installation Guide
,
Document 800-00008, Revision A
43
The following table indicates the status associated with each LED.
Note:
The Ethernet/COM status LED will be green even if no cable is attached.
Table 5
LED Status
LED
PWR
RUN
H485
H232
DS
COM
LINK
RLY
RDR
GREEN
Power
OK
Blink =
normal
Steady =
malfunc-
tion
Multi-
drop
Receive
Data
RS232
Receive
Data
Down-
stream
Receive
Data
100Mbit
Link
OK
Relay
Active
Flash at
read
RED
N/A
N/A
Trans-m
it Data
Trans-m
it Data
Trans-m
it Data
N/A
N/A
N/A
N/A
AMBER
N/A
N/A
TX &
RX
Data
TX &
RX
Data
TX &
RX
Data
N/A
TX &
RX
Data
N/A
N/A
OFF
Power
Off
Mal-
function
No
Com
No
Com
No
Com
10Mbit
No
Link
Relay
Off
Normal