IBM RS6000 Service Guide - Page 108

Table 3-5 (Page 5 of 10). Firmware Checkpoints. Checkpoint Description E175 BootP request E176 E177 E178 E180 E183 E190 E193 E196 E19B E19C E19D E19E TFTP file transfer Transfer failure due to TFTP error condition Create PCI token ring node SP Command setup SP Post Create ISA node Initialize Super I/O. Probe ISA bus. Create Service Processor node. Create tablet node. Create nvram node. Real time clock (RTC) creation and initialization. E19F E1AD E1B0 E1B1 E1B2 E1B3 E1B6 E1BA E1BB E1BC E1BD E1BE Create eeprom node. See description of checkpoint E1DE. Create lpt node. Create serial node. Create audio node. Create 8042 node. Probe for (ISA) keyboard. Enable L2 cache. Set cache parms for burst. Set cache parms for 512KB. Probe for (ISA) mouse. Create op-panel node. 3-36 Service Guide Action/ Possible Failing FRU Refer to "E1xx Code Boot Problems" on page 3-44 for general considerations. 1. Turn off then on, and retry the boot operation. 2. Verify the network connection (network could be down). 3. Have network administrator verify the server configuration for this client. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. Refer to error code 28030xxx in "Firmware/POST Error Codes" on page 3-2. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29. See the note on 3-29.