IBM RS6000 Service Guide - Page 81

Table 3-1 (Page 8 of 24). Firmware Error Codes. Error Code Description 25A80210 Setenv/$Setenv parameter error - name contains a null character. 25A80211 Setenv/$Setenv parameter error - value contains a null character. 25AA0xxx EEPROM problems. 25AA0000 Unable to unlock EEPROM. 25AA0001 Read-Recv error. 25AA0002 Read-Trans error. 25AA0003 Write-enable error. 25AA0004 Write-recv error. 25AA0005 Write-disable error. 25AA0006 Write-Trans error. 25AA0007 Unable to lock EEPROM. 25B00001 No memory modules detected in either memory card 1 or 2. 25Cyyxxx Memory Card problems. Action / Possible Failing FRU Refer to Action under error code 25A80xxx. Refer to Action under error code 25A80xxx. EEPROM problem resolution: 1. Ensure that the EEPROM Security jumper is in the correct position if doing a privileged-access password install. 2. Retry the operation. 3. If retries do not solve the problem, replace the I/O board. (See notes on 3-1.) Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. Refer to Action under error code 25AA0xxx. 1. Reseat any installed memory card(s) and retry. 2. Reseat any installed memory modules on the installed memory cards. 3. Replace Memory Card(s). See "Memory PD Bits" on page 3-26 for definition of "yy". Use the location code obtained from the SMS Error Log utility (described in MAP Step 1020-4) to identify which memory module (or memory module pair) the error is reported against. Chapter 3. Error Code to FRU Index 3-9