IBM RS6000 Service Guide - Page 235
Place the memory card in the card guide rails.
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 235 highlights
Replacement 1. With one hand, touch any metal surface of the chassis to minimize static electrical charges, and then pick up the memory card. 2. Open the retainer hooks. Attention: To prevent damage to the card and the card connectors, open and close the retainer hooks at the same time. 3. Remove the connector cover if you are installing the card in an unused memory card slot. 4. Place the memory card in the card guide rails. 5. Make sure that the black tabs on the new card are captured by the retainer hooks. 6. Align the card with the connector. 7. Close the retainer hooks to set the card. Attention: To prevent damage to the card and the card connectors, open and close the retainer hooks at the same time. Chapter 6. Removal and Replacement Procedures 6-27