IBM RS6000 Service Guide - Page 327
Modem Configuration Samples, Sample File modem_z.cfg
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 327 highlights
Modem Configuration Samples Sample File modem_z.cfg # # COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP Z # # FUNCTIONS: Modem configuration file for many early Hayesᑍ compatible modems. # This example uses the ATZ reset command to choose the factory defaults. # This setup will work for many modems, but it is required for early vintage # modems which respond to neither the ATZ reset command nor the extended (&) # commands. Refer to your modem manual. # # ᑍ Trademark of Hayes Microcomputer Products, Inc. # # (C) COPYRIGHT International Business Machines Corp. 1996 # All Rights Reserved # Licensed Materials - Property of IBM # # US Government Users Restricted Rights - Use, duplication or # disclosure restricted by GSA ADP Schedule Contract with IBM Corp. # # # If the modem has configuration switches, they should be set to the # factory default settings. ICDelay 1 DefaultTO 1 CallDelay 12 # AT Attention Code , Inserts delay in dialing commands # Z Reset to factory defaults Q Turn on responses # E Turn echo off Q1 Turn off responses # V Use numeric responses S = Automatic answer inhibit # +++ Escape to command mode S =2 Answer on second ring # H Hang-up T = Tone mode. When used as T\r, it is a # no op to maintain program synchronization # when modem may/will echo the commands. # # %N Call-Out phone number %P Paging phone number # %S Modem speed (available to users) # # Following are common responses from a wide range of modems: # 16, 15, 12, 1 , 5 and 1 are connection responses. Add others as required. # 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; =OK # # PROGRAMMING NOTE: No blanks between double quote marks ("). condout: send "ATZQ T\r" ignore " \r" or "OK\r\n" timeout 2 send "ATE T\r" expect " \r" or "OK\r\n" timeout 2 send "ATQ V T\r" expect " \r" timeout 2 send "ATS = \r" expect " \r" timeout 2 done # Reset to factory defaults. # Ignore modem response. # Initialize modem: Echo OFF, # Enable responses (Numeric), # Limit response codes. # Confirm commands successful. # Set AutoAnswer OFF # Confirm command successful. connect: send "ATDT%N\r" # Tone dialing command. # %N from Call Home setup. # Expect a connection response. expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r" busy "7\r" timeout 6 done Appendix D. Modem Configurations D-9