IBM RS6000 Service Guide - Page 76

Table 3-1 (Page 3 of 24). Firmware Error Codes. Error Code Description 20E0000A EEPROM lock problem. 20E0000B EEPROM write problem 20E0000C EEPROM read problem. 20E00017 20EE0xxx 20EE0003 Cold boot needed for password entry. Informational IP parameter requires 3 dots "." 20EE0004 Invalid IP parameter. 20EE0005 Invalid IP parameter (>255) 20EE0006 No SCSI controllers present 20EE0007 Keyboard not found 20EE0008 No configurable adapters found in the system. 20EE0009 Unable to communicate with the Service processor. Action / Possible Failing FRU If for privileged-access password install, is jumper in correct position? Consult the system's User's Guide for jumper location and position. 1. Turn off, turn on system unit. 2. Replace I/O board. (See notes on 3-1.) 1. Turn off, turn on system unit. 2. Replace I/O board. (See notes on 3-1.) 1. Turn off, turn on system unit. 2. Replace I/O board. (See notes on 3-1.) Turn off, turn on system unit. Enter valid IP parameter. Example: 000.000.000.000 Enter valid (numeric) IP parameter. Example: 000.000.000.000 Enter valid (numeric) IP parameter in the range of 0 to 255. Example: 255.192.002.000 The I/O board should always have (at least) 2 integrated PCI SCSI controllers; replace the I/O board. (See notes on 3-1.) 1. Plug in keyboard. 2. Replace I/O board, (See notes on 3-1.) This warning occurs when the selected SMS function cannot locate any devices/adapters supported by the function. If a supported device is installed: 1. Replace the device or adapter. 2. Replace I/O board, (See notes on 3-1.) 1. Replace the Service Processor. 2. Replace I/O board, (See notes on 3-1.) 3. Replace System Board. 3-4 Service Guide