IBM RS6000 Service Guide - Page 74
Firmware/POST Error Codes
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Firmware/POST Error Codes If you replace FRUs and the problem is still not corrected, go to "MAP 1540: Minimum Configuration" on page 2-17 If you replace FRUs and the problem is corrected, go to "MAP 410: Repair Checkout" in the IBM RS/6000 Diagnostic Information for Multiple Bus Systems Table 3-1 (Page 1 of 24). Firmware Error Codes. Error Code Description 203w0xyz w=loop number x=0 missing link y=port number z=c for interconnect z=b missing link back z=E RIO de-configured 20A80xxx Remote initial program load (RIPL) error. 20A80000 Insufficient information to boot. 20A80001 Client IP address is already in use by other network device. 20A80002 Cannot get gateway IP address. 20A80003 Cannot get server hardware address. 20A80004 Bootp failed. 20A80005 20D00xxx 20D0000F File transmission (TFTP) failed. Unknown/Unrecognized device Self-test failed on device, no error/location code information available. Action / Possible Failing FRU Check Cables, then Remote I/O. Verify the IP address. Change IP address. Refer to "Checkpoints" on page 3-29 table using code E174. Refer to "Checkpoints" on page 3-29 table using code E174. 1. Refer to "E1xx Code Boot Problems" on page 3-44 for general considerations. 2. Turn off then on, and retry the boot operation. 3. Verify Boot List by using the Firmware SMS Multiboot menus. 4. Verify the network conection (network could be down). 5. Have network administrator verify the server configuration for this client. Check network connection, try again. Check the System Management Services error log entry (described in "Step 1020-4" on page 2-11) for this error code. The location code (if present) in the error log entry should identify the location of the failing device. 3-2 Service Guide