IBM RS6000 Service Guide - Page 75

Table 3-1 (Page 2 of 24). Firmware Error Codes. Error Code Description 20D00010 Self-test failed on device, can't locate package. 20D00011 Cannot determine Machine Model. 20E00xxx 20E00000 Security Power on Password entry error. 20E00001 Privileged-access password entry error. 20E00002 Privileged-access password jumper not enabled. 20E00003 Power on Password must be set for Unattended mode. 20E00004 Battery drained or needs replacement. 20E00005 EEPROM locked. 20E00008 CMOS corrupted or tampering evident, CMOS initialized. 20E00009 Invalid password entered - system locked. Action / Possible Failing FRU Contact you service support representative for assistance. The Machine Model is part of the System Vital Product Data. Perform corrective actions listed for errors 2BA00050, 2BA00051. The password has been entered incorrectly. Retry installing the password. The password has been entered incorrectly. Retry installing the password. The privileged-access password jumper is not in the correct position for password initial entry. Consult the system's User's Guide for jumper location and position. Unattended mode requires the setting of the Power On password before it is enabled. 1. Replace battery. 2. Replace I/O board. (See notes on 3-1.) 1. Turn off, then turn on system unit. 2. Replace the I/O board. (See notes on 3-1.) Check your machine for evidence of tampering. If no tampering evident: 1. Replace battery, restore NVRAM data (passwords, startup data). 2. Replace I/O board. (See notes on 3-1.) The password has been entered incorrectly 3 times. Turn off, then turn on the system unit, then enter the password correctly. Chapter 3. Error Code to FRU Index 3-3