IBM RS6000 Service Guide - Page 337
Sample File modem_f1.cfg
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 337 highlights
Sample File modem_f1.cfg # # COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F1 # # FUNCTIONS: Modem configuration file for many recent Hayesᑍ compatible modems. # This example uses the AT&F1 reset command to choose the factory defaults. # This set up is for modems with extended (&) commands and which do not work # properly with setup F . For early vintage modems, setup Z or Z is # recommended. # # ᑍ Trademark of Hayes Microcomputer Products, Inc. # # (C) COPYRIGHT International Business Machines Corp. 1996 # All Rights Reserved # Licensed Materials - Property of IBM # # US Government Users Restricted Rights - Use, duplication or # disclosure restricted by GSA ADP Schedule Contract with IBM Corp. # # # If the modem has configuration switches, they should be set to the # factory default settings. ICDelay 1 DefaultTO 1 CallDelay 12 # AT Attention Code , Inserts delay in dialing commands # &F1 Reset. Restore profile 1 Q Turn on responses # E Turn echo off Q1 Turn off responses # V Use numeric responses S = Automatic answer inhibit # +++ Escape to command mode S =2 Answer on second ring # H Hang-up X = Limit modem response codes # T = Tone mode. When used as T\r, it is a # no op to maintain program synchronization # when modem may/will echo the commands. # # &C1 Detect CD &D2 Respond to DTR (often the default) # &R1 Ignore RTS (CTS) # # %N Call-Out phone number %P Paging phone number # %S Modem speed (available to users) # # Following are common responses from a wide range of modems: # 16, 15, 12, 1 , 5 and 1 are connection responses. Add others as required. # 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; =OK # # PROGRAMMING NOTE: No blanks between double quote marks ("). condout: send "AT&F1Q T\r" ignore " \r" or "OK\r\n" timeout 2 send "ATE T\r" expect " \r" or "OK\r\n" timeout 2 send "ATQ V X T\r" expect " \r" timeout 2 send "ATS = \r" expect " \r" timeout 2 send "AT&C1&D2&R1\r" expect " \r" timeout 2 done # Reset modem. Select profile 1 # Ignore modem response. # Initialize modem: Echo OFF, # Enable responses (Numeric), # Limit response codes. # Confirm commands successful. # Set AutoAnswer OFF # Confirm command successful. # Detect carrier and DTR, # Ignore RTS. # Confirm command successful. connect: send "ATDT%N\r" # Tone dialing command. # %N from Call Home setup. # Expect a connection response. expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r" busy "7\r" Appendix D. Modem Configurations D-19