IBM RS6000 Service Guide - Page 245
Service Processor, Removal, Replacement
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
Service Processor Removal 1. If you have not already done so, remove the covers as described in "Covers" on page 6-3. 2. Remove the I/O planar cover as described on page 6-8. Attention: Make sure the power cord is unplugged and the power LED is OFF before removing the service processor. 3. Remove the service processor. Replacement To replace the service processor, perform the removal steps in the reverse order. Chapter 6. Removal and Replacement Procedures 6-37
Service Processor
Removal
1. If you have not already done so, remove the covers as described in “Covers” on
page 6-3.
2. Remove the I/O planar cover as described on page 6-8.
Attention:
Make sure the power cord is unplugged and the power LED is OFF
before removing the service processor.
3. Remove the service processor.
Replacement
To replace the service processor, perform the removal steps in the reverse order.
Chapter
6.
Removal and Replacement Procedures
6-37