IBM RS6000 Service Guide - Page 85
Table, 1 of 24. Firmware Error Codes.
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Table 3-1 (Page 12 of 24). Firmware Error Codes. Error Code Description 2BA00014 Service processor reports bad service processor firmware. 2BA00017 Service processor reports bad or low battery. 2BA00018 EPOW test failure. 2BA00019 IRQ13 test failure. 2BA00024 2BA00040 Service processor reports bad Power Controller firmware. Service processor reports Service Processor VPD module not present. 2BA00041 Service processor VPD is corrupted. 2BA00050 Service processor reports system operator panel VPD module not present or not recognizeable. 2BA00051 System operator panel VPD data corrupted. 2BA00060 2BA00061 2BA00062 2BA00063 Service processor reports I/O board VPD module not present. Service processor reports I/O board VPD data corrupted. Service processor reports system board VPD module not present. Service processor reports system board VPD data corrupted. Action / Possible Failing FRU Use service processor firmware diskette to re-program firmware. 1. Replace the battery. 2. Replace the service processor card. 3. Replace the I/O board. (See notes on 3-1.) 1. Replace the service processor. 2. Replace the I/O board. (See notes on 3-1.) 1. Replace the I/O board. (See notes on 3-1.) 2. Replace the service processor card. Use the System Firmware diskette to re-program the System firmware. 1. Use the Service Processor Firmware diskette to re-program the Service Processor firmware. 2. Replace the Service Processor card. 1. Use the service processor firmware diskette to re-program the service processor firmware. 2. Replace the service processor card. Replace the operator panel control assembly. (See notes on 3-1.) Note: Swap the old VPD module from the old operator panel control assembly to the new one. Replace the operator panel control assembly. (See notes on 3-1.) Note: Swap the old VPD module from the old operator panel control assembly to the new one. Replace the I/O board. (See notes on 3-1.) Replace the I/O board. (See notes on 3-1.) Replace the system board. Replace the system board. Chapter 3. Error Code to FRU Index 3-13