IBM RS6000 Service Guide - Page 58
Step 1540-9
View all IBM RS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Step 1540-9 The system is working correctly with this configuration. One of the FRUs (adapters) that you removed is probably defective. 1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive. 2. Turn the power off and remove the power cable. 3. Plug the diskette drive cable into the diskette drive connector on the I/O planar. 4. Reinstall the power cable. 5. Turn the power on. 6. After the keyboard indicator is displayed, press the F5 key on the directly-attached keyboard or the number 5 key on an ASCII terminal keyboard. 7. Enter the appropriate password when prompted to do so. Is the "Please define the System Console" screen displayed? NO One of the FRUs remaining in the system is defective. In the following order, exchange the FRUs that have not been exchanged. 1. Diskette drive 2. Diskette drive cable 3. I/O planar (see notes on page 2-1). 4. Power supply Repeat this step until the defective FRU is identified or all the FRUs have been exchanged. If the symptom did not change and all the FRUs have been exchanged, call your service support person for assistance. If the symptom has changed check for loose cards, cables, and obvious problems. If you do not find a problem return to "Step 1540-1" on page 2-18 in this MAP and follow the instructions for the new symptom. YES Go to "Step 1540-10" on page 2-29. 2-28 Service Guide