Konica Minolta AccurioPress C2070 IC-314 User Guide - Page 101

Profiles 91 1. From the Tools menu, select Profiling Tool. 2. Select Print and measure chart. 3. Click Next. 4. Perform the following actions: a. In the Measuring device list, select the i1 spectrophotometer as the measuring device that you will use to measure the color chart. b. In the Warm up copies box, select the number of copies of the warm-up file that you want to print. c. In the Tray list, select the tray in which the paper stock for which you want to create a profile is loaded. d. In the Screening list, select the screening method for the profile. e. In the Calibration list, select the relevant calibration table. Linked is the default setting (highly recommended). f. In the Number of copies box, select the number of copies of the chart that you want to print. 5. Click Print. The color measurement chart and the warm-up file are printed. 6. Place the color measurement chart on a clean flat surface. 7. Click Measure and perform the following actions. a. Press the button located on the measurement device. b. When you hear a beep, scan the device across strip 1 in the following manner: Note: To avoid measurement failures, perform the following steps to scan the strip: 1. Position the measurement device at the start of the white box in the strip. 2. Scan from the left white box across to the right white box. A green check mark is displayed when the measurement is successful. A red x mark is displayed if the measurement fails. c. Continue to scan the remaining strips on the color chart pages. 8. (Optional) To save the measurement file and load it at a later time, locate a folder and in the Save in box, type a name for the measurement file. 9. (Optional) Click Save.