Konica Minolta AccurioPress C2070 IC-314 User Guide - Page 48
Using the Konica Minolta FD-9 spectrophotometer to create a calibration table, Requirements, Tools
View all Konica Minolta AccurioPress C2070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
38 Chapter 3-Calibration Using the Konica Minolta FD-9 spectrophotometer to create a calibration table Requirements: ● Your FD-9 spectrophotometer must be connected to the USB port on the IC-314 print controller, and then turned on. The first time that you connect the device to the IC-314 print controller, you are notified that the driver is being installed. Wait for the driver installation to finish before proceeding further. ● Make sure that your spectrophotometer is calibrated. Refer to the spectrophotometer product documentation for more information. ● The Print queue must be enabled and the printer must be in Ready mode. Note: The FD-9 device can be connected via local USB port or network. If more than one FD-9 device is connected (via USB or network), you will be prompted to choose which FD-9 device to use for the calibration process. 1. From the Tools menu, select Calibration or click the Calibration icon on the toolbar. 2. In the Measuring device list, make sure that FD-9 is selected. The following message appears while the IC-314 print controller connects to the FD‑9.