Konica Minolta ProJet 160 Cube3 User Guide - Page 91

Test Print

Get Konica Minolta ProJet 160 PDF manuals and user guides View all Konica Minolta ProJet 160 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 91 highlights

TEST PRINT Test print allows you to print the same welcome message that is printed during the initial setup of the printer. The print is very useful for determining if the gap between the left print jet and the print pad is correct. 1. Select TEST PRINT. 2. Select PRINT. NOTE: If the color built into the test print does not match a color of one of the installed cartridges, the printer will assign an installed cartridge color to the test print. 3. Apply two thin layers of Cube Glue to the print pad. Select the checkmark to continue. NOTE: Apply enough glue to cover a square area of 5" (15 cm). NOTE: For best results, allow the glue to dry before printing. 3D Systems, Inc. 87

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
87
3D Systems, Inc
.
TEST PRINT
Test print allows you to print the same welcome message that is printed during the initial setup of the printer° The print is very useful for
determining if the gap between the left print jet and the print pad is correct°
1°
Select
TEST PRINT
°
2°
Select
PRINT
°
NOTE: If the color built into the test print does not match a
color of one of the installed cartridges, the printer will assign an
installed cartridge color to the test print°
3°
Apply two thin layers of Cube Glue to the print pad° Select the checkmark to
continue°
NOTE: Apply enough glue to cover a square area of 5” (15 cm)°
NOTE: For best results, allow the glue to dry before printing°