Kyocera KM-C830D KM-C830 Operation Guide Rev-1B - Page 110

Section 7 COPIER MANAGEMENT Default setting * Insert tray Description Available settings Factory setting Sets the drawer that contains the paper which will be fed in the insert sheet modes (page 6-26). * No.3 and No.4 drawers can only be selected when the optional Paper Feeder is installed in your copier. Standard copiers 1 paper [SOURCE 1] - 4 paper [SOURCE 4] / Bypass Duplex copiers 2 paper [SOURCE 2] - 4 paper [SOURCE 4] / Bypass 2 paper [SOURCE 2] Reference page 7-21 ( Sort mode ON/OFF Sets the default setting for the sort mode at the time On / Off Off (Output form) power is turned on. 7-21 ) Eject destination Sets the location for ejection of finished copies: the copy eject tray (side) or the copy storage table (inner). Inner Eject / Side Eject Inner Eject 7-22 ⁄ ACS adjustment Adjusts the level of detection between color and 1 - 5 1 7-22 black&white originals in the Auto Color Selection mode (page 4-1). ¤ Auto color adjustment Slight changes in color copying may take place if --- your color copier is used over a long period of time. If the color on the originals and that which appears on the copies begins to differ greatly, use this procedure to adjust the color. --- 7-22 ‹ Drum refresh This operation should be performed when high --- humidity causes the copy image to become blurred or faded. The operation will take approximately 5 minutes. --- 7-23 › Rotate sort ON/OFF Selects between standard sorting (page 6-46) or On / Off Off rotate-sorting (page 6-46) as the default sort mode whenever the sort mode is selected. * In order to use this setting, there must be 11" x 8 1/2 and 8 1/2" x 11" [B5 and B5R or A4 and A4R] paper set in the drawers. (8 1/2" x 11" and A4R paper can be loaded into the optional Paper Feeder, while B5 paper can be set onto the multi- bypass tray. However, 2-sided copies cannot be made automatically when paper is being fed from the multi-bypass tray.) 7-23 7-15