Kyocera KM-C830D KM-C830 Operation Guide Rev-1B - Page 118

Section 7 COPIER MANAGEMENT 5 Once print out is complete, set the printed color pattern on the platen. NOTES • Set the PG color pattern on the platen so that the 3 squares are located on the left side as shown in the illustration. 10 Press the Enter key. 11 Set an original and press the Start key. A test copy will be printed out and the message display will return to the screen in step 7. • Press the Stop/Clear key if you want to cancel the auto color adjustment procedure. 6 Press the Start key. The set PG color pattern will be scanned and auto color adjustment performed automatically. 7 Once adjustment is completed, the "Auto Adjustment (Text&Photo)" screen will appear. Use the M cursor or the N cursor key to select between "z Adjust Finish" ["z ADJUSTMENT COMPLETED"], "x Test Copy" and "c Adjust Again". Inch specifications 12 Press the Enter key. The message display will return to the screen in step 3. Repeat steps 4 through 7. ‹ Drum refresh 1 Press the Enter key. The drum refresh operation will begin. Please wait about 5 minutes. Inch specifications Metric specifications Metric specifications • If you are finished with auto color adjustment, select "z Adjust Finish" ["z ADJUSTMENT COMPLETED"] and go to the next step. • If you want to make a test copy, select "x Test Copy" and go directly to step 10. • If you want to perform auto color adjustment again, select "c Adjust Again" and proceed directly to step 12. 8 Press the Enter key. The message display will return to the screen in step 2. 9 Use the L cursor or the M cursor key to select "z End" and then press the Enter key. 2 Once the drum refresh operation is complete, press the Enter key. › Rotate sort ON/OFF 1 Use the M cursor or the N cursor key to select either "z On" or "x Off". Inch specifications Metric specifications 2 Press the Enter key. 7-23