Kyocera KM-C830D KM-C830 Operation Guide Rev-1B - Page 25
Setting paper on the multi-bypass tray
View all Kyocera KM-C830D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Section 3 PREPARATIONS 8 Insert the appropriate paper size label into the front of the drawer to indicate the size of paper that is loaded into that drawer. NOTE If you will not be using the copier for a prolonged period of time, remove all paper from the drawer(s) and seal in its original packaging in order to protect it against moisture. 1 Open the multi-bypass tray. (3) Setting paper on the multi-bypass tray Up to 150 sheets of standard paper (75 g/m2 - 90 g/m2) can be set on the multi-bypass tray. Paper sizes between 5 1/2" x 8 1/2", 8 1/2" x 5 1/2", 8 1/2" x 11, 11" x 8 1/2", 8 1/2" x 14, 11" x 17" and 12" x 18" [B6R, A5R, B5R, B5, A4R, A4, B4, A3, A3 wide (305 mm x 457 mm) and Folio] can be used. When copying onto special paper, be sure to use the multi-bypass tray. NOTE • The following types of special paper and the number of sheets that can be set on the multi-bypass tray at one time are as follows: OHP transparencies: 25 sheets (BE SURE to use only 11" x 8 1/2" [A4] size OHP transparencies and ALWAYS fan through transparencies before setting them on the multi-bypass tray.) Thick paper (91 g/m2 - 220 g/m2): 50 sheets • The acceptable paper weight for thick paper actually differs depending upon the size of the paper: Under 11" x 8 1/2" [A4]: 91g/m2 - 220 g/m2 Over 11" x 8 1/2" [A4]: 91g/m2 - 135 g/m2 NOTE When copying onto 8 1/2" x 11" [A4R] size paper or larger, be sure to pull out the multi-bypass extension. 2 Adjust the insert guides to fit the width of the paper that is to be set on the multi-bypass tray. IMPORTANT! • BE SURE to use paper that is specified for color copy use in order to make clear color copies. • DO NOT use paper such as that designated for inkjet printers or any paper treated with special coating. • When setting special paper such as OHP transparencies and thick paper on the multi-bypass tray, be sure to specify the type of paper under "G When setting OHP transparencies or thick paper on the multi-bypass tray" on page 3-5. 3-3