Kyocera KM-C830D KM-C830 Operation Guide Rev-1B - Page 135
Message, Procedure, Reference
View all Kyocera KM-C830D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Message "Change bypass paper size" "CHANGE BYPASS PAPER SIZE." Section 9 TROUBLESHOOTING Procedure Copying is not possible at the paper size selected for the multibypass tray. Change the paper size setting. Reference page 3-4 "Exceeded copy quantity limit." The number of copies made under your department code has 7-1 reached the limit that was set under the copy management mode "COPY LIMIT REACHED. NO COPYING" and copying is no longer possible with that code. Use the copy management mode to clear the copy count. "Set toner container." "SET TONER CONTAINER." One or more of the toner containers is not set or are not set properly. 3-8 Set the toner containers properly. "Ready to copy. Add toner. (KCMY)" There is insufficient toner left in the indicated toner container. 3-8 Replace the corresponding toner cartridge as soon as possible "READY TO COPY. ADD TONER. (KCMY)" (C = cyan, M = magenta, Y = yellow, K = black). "Add toner to resume copying. (KCMY)" The copier has run out of toner of the color indicated. Replace the 3-8 corresponding toner cartridge immediately (C = cyan, M = magenta, "ADD TONER TO RESUME COPYING. (KCMY)" Y = yellow, K = black). "Ready to copy. Time to replace the oil kit" "READY TO COPY. TIME TO REPLACE THE OIL KIT." It is almost time to replace the oil kit. Replace the oil roller as soon as possible. 3-13 "Replace the oil kit now. Unable to copy." "REPLACE THE OIL KIT NOW. CANNOT COPY." Replacement of the oil kit is required. Replace the oil roller immediately. 3-13 "Check waste toner tank." "CHANGE WASTE TONER TANK." • The waste toner tank is full. Replace the waste toner tank. 3-8 • The waste toner tank is not set properly. Set the toner waste toner tank properly. "Call for service." "CALL FOR SERVICE." Open and then close the front cover. If this message still remains, make a note of the number that displayed with the "C", turn the main switch OFF ( ), and contact your service representative or authorized service center. -- "System error. Main switch off / on." "SYSTEM ERROR. MAIN SWITCH OFF / ON." An error has occurred. Turn the main switch OFF ( ) and then back ON ( | ) again. -- "Time for maintenance" "TIME FOR MAINTENANCE" Periodic maintenance is required to keep your copier in good condition. Contact your service representative or authorized service center as soon as possible. -- "Memory is full." "MEMORY IS FULL." The copier's memory is full. Select whether you want to print out that data that is already scanned or delete all of that data. It will not be possible to copy or scan another original until one of these two operations is performed. -- 9-2